 | A torque wrench is not required for installation! No amount of tightening will
cause shorting between positive and negative heat sinks. The crush proof insulator gasket
is compression rated at 65,000 psi, which means you can over torque this rectifier until
the bolts break without shorting out the heat sinks... |
| Our patented design eliminates the silicone insulator gasket others must use for
heat transfer. The 3 copper 'L' diode supports, increase heat transfer out of the positive
diodes 50% faster than directly into aluminum, eliminating positive heat
sink diode failure... |
| High temperature springs prevent the diodes from shifting or arcing during an
overload situation. If the solder should liquify, the diodes will resolder themselves as
the assembly cools... |
| The alternator positive lug will stay tight because the fiberglass gasket won't
compress... |
![EDE Logo Image]](images/EDElogo100gw.gif)
